操作 如何操作折弯机

折弯机的操作

概述

折弯机广泛用于世界各地的制造行业，对金属板材和板材进行成型。该过程从将金属送入机器开始，在机器中将具有所需形状的冲头和模具应用于金属板，以将其弯曲或折叠成该形状。

安全程序

在开始操作之前，必须始终遵守安全准则以确保安全：

• 佩戴合适的安全装备 – safety goggles, hard hat and protective workplace clothing should be worn to reduce the risk of injury.
• 检查机器设置 – always check the machine setup before starting it up. The pressure, clearance and alignment of machine components should match the requirements of the job to ensure correct operation.
• 检查金属 – check the metal to ensure there are no bends, cracks or sharp edges that can cause injury or hamper the operation.
• 确保机器关闭并且连接的平台高度处于最低 – make sure the machine is off and the attached platform is at its lowest to prevent accidents.

指示

• 启动机器 – switch on the machine and ensure that all parts are running correctly.
• 将金属放置到位 – load the metal into the machine according to the required shape and check for any distortions.
• 设定压力 – adjust the pressure of the machine according to the thickness of the metal for accurate and safe operation.
• 开始循环 – press the buttons to start the cycle and ensure that the machine is performing correctly and the metal has taken the desired shape.
• 取下夹子 – release the clamps that secure the metal once the cycle is complete and remove the finished product.
• 关闭机器 – set the attached platform to its lowest position and switch off the machine after completing the cycle.

结论

如果遵循安全准则并定期检查设置和组件，折弯机的操作相对简单且安全。在遵循适当的说明后，操作员应该能够准确地创建所需的形状，从而能够快速高效地生产金属零件。