عملية كيفية تشغيل آلة ضغط الفرامل


تشغيل آلة ضغط الفرامل

ملخص

تستخدم آلات الضغط على نطاق واسع في صناعات التصنيع في جميع أنحاء العالم ، لتشكيل الصفائح والألواح المعدنية. تبدأ العملية بتغذية المعدن في الماكينة ، حيث يتم وضع مثقبة وقوالب بالشكل المطلوب ، على اللوحة المعدنية لثنيها أو طيها في هذا الشكل.

إجراءات السلامة

قبل بدء التشغيل ، يجب دائمًا الحفاظ على السلامة باتباع إرشادات السلامة:

  • ارتدِ معدات السلامة المناسبة – safety goggles, hard hat and protective workplace clothing should be worn to reduce the risk of injury.
  • تحقق من إعداد الجهاز – always check the machine setup before starting it up. The pressure, clearance and alignment of machine components should match the requirements of the job to ensure correct operation.
  • تحقق من المعدن – check the metal to ensure there are no bends, cracks or sharp edges that can cause injury or hamper the operation.
  • تأكد من إيقاف تشغيل الماكينة وأن ارتفاع المنصة المرفقة في أدنى مستوياته – make sure the machine is off and the attached platform is at its lowest to prevent accidents.

تعليمات

  • ابدأ تشغيل الجهاز – switch on the machine and ensure that all parts are running correctly.
  • ضع المعدن في الموضع – load the metal into the machine according to the required shape and check for any distortions.
  • اضبط الضغط – adjust the pressure of the machine according to the thickness of the metal for accurate and safe operation.
  • ابدأ الدورة – press the buttons to start the cycle and ensure that the machine is performing correctly and the metal has taken the desired shape.
  • قم بإزالة المشابك – release the clamps that secure the metal once the cycle is complete and remove the finished product.
  • أوقف تشغيل الجهاز – set the attached platform to its lowest position and switch off the machine after completing the cycle.

خاتمة

يعتبر تشغيل آلة الضغط على المكابح أمرًا سهلاً وآمنًا نسبيًا ، بشرط اتباع إرشادات السلامة وفحص الإعداد والمكونات بانتظام. بعد اتباع التعليمات المناسبة ، يجب أن يكون المشغل قادرًا على إنشاء الشكل المطلوب بدقة ، مما يسمح بالإنتاج السريع والفعال للأجزاء المعدنية.

شارك على facebook
فيسبوك
شارك على twitter
تويتر
شارك على linkedin
ينكدين

المزيد من معلومات آلة الانحناء

اطلب اقتباس